Archive

Archive for the ‘Welding Techniques’ Category

CIG Transtig 150 Cigweld Tig Welder

September 5th, 2014 Comments off

CIG Transtig 150 TIG Welder

The Cigweld Transtig 150 is an AC DC Tig Welding Machine that is based on a transformer, the old school type unlike the modern inverter welding machines. AC DC Tig Welding or DC TIG welding is achieved by swapping the orange leads polarity by either allowing them to go straight through or criss cross each other.

The welder can handle the following duty cycles. 60 Amps at 100%, 120 Amps at 25%, 150 Amps at 17%. Duty cycle is calculated at % of time in a ten minute repeating period. 100% weld all day at that setting, 70% weld for 7 minutes at that setting then rest for 3 minutes, 40% weld for 4 minutes rest for 6 minutes etc.So at 120 Amps, the welder could run for 150 seconds, rest for 450 seconds then repeat.

Straight off the trusty trailer. It weighs about 90 kilos.

This gives me pleasure. Involving kids in the active participation of pulling stuff apart. Alek(6) is turning into me ever so slowly. He just needs to grow taller and lose his hair.

The ratchet was too boring, apprentice needs some action. In comes the power assisted ratchet.

No mouse wheels in here, just hard core copper with a lot of electrical things.

A close up the heatsinks reveals a lot of built up dust. I quick blow out with the compressor and we are clean.

This is the electronic control board that sits behind the front panel. It was clean as it is sealed in it’s own box.

Finished with the clean up. The front panel has pre and post gas control timers, Current selector, arc force selector, TIG or manual ARC switch. The AC / DC is selected by crossing over the orange leads.

Alek and Marcus(4) pleased with the result. They then set about like a couple of raptors insisting I power it up and start welding. Look at ’em, anyone would think it was theirs the way they pose.

Here is a shot of the foot controller and TIG gun. The foot controller also varies the current.

Here is a shot of the unit with the argon attached. The power source is clean and shiny. Almost like new.

Spare collets, electrodes, gas shrouds and a “feed wire holder” on the right.

Here is the manual arc electrode holder. Note the small hand held push button.

Categories: Tig Welding, Welders, Welding Aluminium Tags:

How To Tig Welding Stainless Steel Pipe

April 19th, 2012 Comments off

how to tig welding stainless steel pipe

tig welding stainless steel 3/4 inch pipe.


Categories: Welding Stainless Steel Tags:

Tig Welding Stainless Steel Settings

April 7th, 2012 Comments off

tig welding stainless steel settings

Tips for Tig Welding Stainless Steel using Pulse Settings


Categories: Welding Stainless Steel Tags:

Tig Welding Stainless Steel Jobs Ca

March 25th, 2012 Comments off

tig welding stainless steel jobs ca

Linmark Machine Products – Union, Missouri


Categories: Welding Stainless Steel Tags:

Tig Welding Stainless Steel Pipe Root

March 24th, 2012 Comments off

tig welding stainless steel pipe root

stt, rmd,smart mig, welding stainless steel pipe without purge root pass part 1 of 3

Categories: Welding Stainless Steel Tags: